September 30, 200421 yr on my 88 RX it only works on high(or fan speed 4) and even then its kind of weak. Is this the fan resistor thing?
September 30, 200421 yr Author does anybody have the link for the fix then? I can't seem to find it by searching.
September 30, 200421 yr does anybody have the link for the fix then? I can't seem to find it by searching.I just pull the resistor blocks at the yard and keep changing them out. If your looking for a more permanent fix: http://www.ultimatesubaru.org/forum/showthread.php?t=2614&page=2&pp=20&highlight=resistor+block Or maybe http://electronickits.com/kit/complete/motor/ck1400.htm Good luck.
September 30, 200421 yr Look at them; there are three coils of resistor wire. If any one or all of them are broken the unit is no good. Be very careful handling the wires, they are very fragile after all this time and you might pull a good one and find a broken wire on it when you get home. Your best bet is to look for the newest Loyale or GL model you can fine (same unit from '81 to '93). how do you know which ones are good?
October 7, 200421 yr where are they at? I've looked and I can't find them There's a good pic in this link. http://www.ultimatesubaru.org/forum/showthread.php?t=10108&highlight=resistor+block
October 7, 200421 yr mine did the same type of thing where it only worked in one selection, only in that instance it was the temp select (knew it was heating, it just wasn't blowing) turned out to be the switch wiring problem. those slanted consoles have a lot of problems, go out quick and whatnot. however i am not sure about the knob... i think you should go for the swap out, i don't have any better pictures, but you could get one cheap, and that will likely solve your problem. if it doesn't, look into it being a wiring problem.
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now