Use the circles as a guide. I need to know where the two hoses on the bottom right-hand side of the blue circle plug into.

 

I also need to know where the two rubber hoses on the right side of the green circle (at 3:00 position) plug into.

 

 

Here's my situation below:

 

 

 

The car will almost be drivable after figuring this out. I need to fix an intake piece as well.

the green circle is the injector resistor pack. no lines shold go to that. there is a turbo managment valve behind it. that goes to the wase gate actuator I think.

 

the blue circle is the stupid sensor that turns on the turbo light. that line goes to a reducer then to the manifold on the right side.

 

the line with a curl on the end comes off the pressure side of the turbo I think.

 

for future line removal try painting or marking the lines color code style.

The red circle should be the cruise control actuator valve. One tube goes to the vacuum side of the intake, other goes to the actuator above the gas peddle.

doh.. I get it. the circles are just points of referance.

 

well my previous statment should still help you out.

doh.. I get it. the circles are just points of referance.

 

well my previous statment should still help you out.

Yes, they help. Thanks!

 

I 'stole' the circled pics from another thread in which I took this pic and someone modified it to help me...yet again.

 

And I know better to label/mark rubber hoses. I just went about tearing at stuff like a moron. Oops!

Yeah, I made that fer ya Kevin. :-p

 

Id take that silly turbo valve off, and just run a short line between the compressor housing and wastegate actuator, like the 85~86 turbo cars do.