Jump to content
Ultimate Subaru Message Board
7point62fmj

how muh for machine work

Recommended Posts

I am going to get my heads decked (and a few other things) for my brat.. I am thinking .025 or should I go .020?

So how much did you pay or should I expect to pay.

Share this post


Link to post
Share on other sites
I am going to get my heads decked (and a few other things) for my brat.. I am thinking .025 or should I go .020?

So how much did you pay or should I expect to pay.

I suggest http://ramengines.com/ to do the machine work they speacialize in suburus.Email ron and he will give you a quick answer on anything you throw at him.

Share this post


Link to post
Share on other sites

$40 per head for milling. if you're talking complete valve job, pressure tested and milled, about $150. add $25 - $40 for any cracks between valves seats that may need repaired. i would consider these on the high end of prices since prices are higher around where i live. you can get a few bucks lower in more rural areas.

Share this post


Link to post
Share on other sites

You may as well get the valves/seats re faced since you've got the heads off. I very much doubt you'll need new guides (best to check though), so just do the re facing and valve seals. Shouldn't cost much at all.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×