Hello

 

I found a dual range transmission here in the usa from a 1997 jdm 2.0 turbo legacy. Can anybody tell me what the gearing is. The trans ID says

64-ty752x1dca. Since its a turbo does it have 4.11 gearing or is it like the older 91 turbos that had like 3.7 or 3.9 gears. It comes with: tranny, linkages, drive shaft, rear diff and halfshafts. Is there anything else I need to get so it will just bolt right in. I have a 97 impreza. Is there any problems Im going to run into with using a jdm transmission in my usa impreza. Will it plug into my tranny harness and run of my tcu if the manual has one. Does the turbo use different axles in the tranny or the rear diff, like do turbos have a different spline count or are the axles different lengths or diameters. Also is a dual range tranny longer then a normal awd ej tranny. They don't have the center console, so I think I could just mod a ea82 console to work or just mod a regular impreza console.

Will this won't bolt right in?

 

Thanks in advance

Ej series all used the same bellhousings...

You might find what you need here (from the USRM):

http://www.northursalia.com/techdocs/trannychart/trannychart.pdf

Thanks for the link, I already had checked that but couldn't find one that matched up so I think the junkyard didn't give me the right one.

You must be careful if your trying to ID a tranny.

Looking for the Adama apple isn't enough. And the pants buldge isn't a sure thing or not. The only sure fire way is to crank the nuts. If you do have a tranny it won't like that.