Hey yall, heres the dealio. I have a Gen 1 brat with this type pf bumper, I know its like a factory/dealer option or something, and I really like it

http://www.indysworld.com/80s/general/pushbar/gen1-full.jpg

BUT, someone cut the headlight gaurd hoop off mine, and I want to rebuild it. I am asking if someone who has one of these bumpers (Moosens, I know you have one :wink:) could take a couple measurements so I can rebuild mine. I need to know:

-the distance to centerline of the hoop where it attaches at the sides from the end of the bumper

-the distance between the centerlines of where the hoop attaches to the bumper

-the distance to centerline of the hoop from the front and back of the bumper

-the diameter and a guesstimate of the thickness of the wall tubing used to make the hoop

 

maybe a pic with the dimensions marked would be the best way? Thanks in advance!

 

Oh, this will be on a Brat of mine that will be given a restoration of sorts, with a few of the factory options like high roll bar, winch, and Jackman wheels, and cranked up a little higher than stock. It will be the one on the right as it has less major rust. Both will be revived eventually though

-Bill

I'll do what I can. Wanna buy one? I have to ship a Stage I 4WD bar out your way already.

How much would you be looking for? Shipping must be killer on something like that

-Bill

East coast rip off price is around $150 :-\ REally though if you have to find one here then its worth the $150 for sure. To you guys ....well,I'm not so sure that's worth it since these pop up all the time out there,right? Shipping - around $60 I'm sure.

I know this is an older thread but I'd like to know the answer to the question as well as add I'd like to know the size of the beam that the piece in the original question is mounted to. Anyone?

AND, what does it mount to on the lower end? It looks like it uses the tow hooks or somethin'