March 15, 200917 yr going to do a full re-seal and change out the front input bearing in my 5MT. What are the torque specs for the bolts on the case, or any critical bolt torque specs. I have read the writeup on it. Any other helpfull tips?
March 17, 200917 yr http://www.ultimatesubaru.org/forum/showthread.php?t=90182&highlight=input+shaft+seal Was this the thread you read?...I thought this was a great tutorial...The only thing i can tell you about the bolts on the case is this....i have personally never done this job but i have done countless viscous couplers by pulling the tailhousing off...as for the torque spec ive never really looked one up...for the 14mm's that hold on the tailhousing I just use my 3/8 impact and snug them up...have never had a comeback from one yet...knock on wood...hope this helps....good luck with the job...
March 17, 200917 yr i think it's in the 28 - 32 ft lb range, but i don't have my haynes manual with me so you will need to double check that. also, at least one is really tough to get to with a torque wrench so i just matched it by feel to the ones i torqued. you can always go back and tighten them, but it's a real b!tch if you strip one out.
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now