Leaderboard

Thank you everyone. I looked up Unisia and found the right one for my '98- about $45 from Amazon. More pricy than the typical Ebay units but far less than if I purchased form Subaru. When i removed the old one, I compared the two and they have the identical part #, so the Unisia Jens is true OEM. The trickiest part was getting it to line up with the hole and getting the bolt started. I could barely get two fingers on the bolt head, but eventually I got it. When I started it up,m it cleatred the CEL on its own and didn't come back on a couple mile drive, so hopefully good to go.

For future reference and others...you can put some tape (or similar) on the bolt head to get it to stick / wedge into the socket to hold it. Then use an extension to reach down and reinstall the bolt. Once it's snug the socket should release. Just be extra careful not to cross-thread it! There's probably an even better way that Mech's know. :-)

I searched around and found a pic that could help, this is supposed to be an Aussie Gen2 outback trailing arm mount; from; http://www.ausubaru.com/forum/archive/index.php/t-10705.html