Captin Hook

No mine just bolted right up. The brackets that hold it to the bumper support were that hardest part.

.

Thanks for the heads up that was my next call over to delta and see if they have any ideas or pointers. After that is to find a machinist.

Got the wheels I got off of Qman ( thanks again) put on.

Alright that covers the rockers, what about lifter, and push rods? What ratio is the rocker, and what's the stud dia?

Most of the pictures didn't post.

Is it even possible? What is needed other then the obvious? Is it worth it?

Yep sure did, there's a perfect spot in the door for them, just put them back far enough so the window car roll down and your good to go.

^ Part # 6596 Euro installation kit. It only works with the 5 bolt signature series steering wheels. You might have to contact grant to get it I had to for my ea81 hub. Had it two days later.

Some puddle lights I installed along with a ea82 done light upgrade, and red under dash lighting all tied in to the door switch.

Vdc stands for vechiel dynamics controll.

There it is on the front of my brat.

It a oe bull bar. The first one I got was for a first gen didn't work, found a secound gen one from a member on the board.

So it won't let me post a pic just pm me your email address and I'll send it right over.

Would help if I had posted the picture to go with it.

Here's the parts break down I'll still get some pictures of my disy when I get off work tonight. This is for an 84 ea81 brat

Sorry been wrapped up in Xmas stuff I'll get a pic before the weeks done.

All that craptochi is off my car so can really help with the wire part.

Looks to be the wrong disy, and maybe. The disy should only have one vac port, I'll snap a picture of my tomorrow for ya.

Might just replace the module in the disty.

Why are you trying to upgrade the dusty?

I can't answer that gd might be the guy to ask on that one.

Yep sure am.

85 brat started stock now msd box and coil, weber swap siting on a ea82 intake manifold, oe intake manifold gaskets, front wheels seals and bearings, cv axels, ball joints, lower control arm bushings, stay bar bushings, anti roll bar bushings, motor mounts, trans mounts, rear diff mustache bar bushings, projector headlights, led conversation inside and out, 2002 outback heated leather seats. That about covers it I think. All parts replaced have been OE.

I've got a street fire by msd cdi box and a blaster ss coil in my 85 brat. Runs like a top, easier cold start up, better idle.