Jump to content
Ultimate Subaru Message Board

90' Loyale Bumpers


Recommended Posts

Hello everyone!

 

I am hoping someone can help, I have a 90' Subaru Loyale with a saggy rear bumper. I crawled around under the car to find how it was attached all I saw was screws that seem to just connect the bumper to the bumper cover.

I searched Hi and low for a repair manual, only found for engin and electrical.

Could someone please tell me how to detach / reinstall bumper?

Many Thanks,

Brian

Link to comment
Share on other sites

If its a wagon, open the rear gate, and then lift up that little "Smugglers hatch" in the floor, you will see 4 rubber plugs (2 per side) there is a 14mm bolt behind each of those plugs. Remove them, and the entire bumper will pull aay from the car.

 

If its a Sedan, you will need to pop off the interior inside the trunk, then you will see the 4 14mm nuts which hold it onto the rear roll pan.

 

-Tom

Link to comment
Share on other sites

Thanks Mr. Loyale for that awesome info, I would have never guest that was under the plugs. Are these the only bolts that hold up the bumper?

It seems like there should be a bracket of some sort under the tail lights, there are 2 holes in the bumper...

Ps it is a Wagon..

 

Thanks again!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...