May 27, 201213 yr 1. Is the xt6 drive shaft the same as in loyals? (the U joints are broken) 2. How rare is the 5 speed tranny? 3. How rare is it to have the rear different lock as well?
May 27, 201213 yr I think the back half is the same. Probably 1/2 of all XT6s had the 5-speed. Rarer than hen's teeth.
May 27, 201213 yr Author okay, just a little background. I am looking at 88 Xt6 (5lug). The rear u Joint's are broken. so modified #1. If the loyal and xt6 drive lines are the same i can Swap them from my 86 gl wagon into the xt6?
May 28, 201213 yr I think I swapped the entire driveline from an ea82 to my xt6. ( rx) Id say the xt6 tranny is a bit rare, I hardly see them in the yards but as far as street use ive done some pretty long commutes the last couple of winters and never used the diff lock regardless of the amount of ice or snow. hankook i pike studded tires and im driving 150 miles each way on rails at freeway speeds:drunk: Ive never seen an lsd rear in any xt6 although they show in the fsm. Very rare. btw, my tranny is having bearing issues now and its half price weekend at pick and pull. I drove ( in my xt6 ) 2 hours each way today to pick up a 22r 5 speed trans, cost 44 bucks . I did a search and the closest xt to me is in calif, so id say rare for sure. still need a tranny though:( Edited May 28, 201213 yr by T'subaru
May 28, 201213 yr I have both the XT6 driveshaft and a 5-speed transaxle but shipping from KY would be a bear.
May 28, 201213 yr okay, just a little background. I am looking at 88 Xt6 (5lug). The rear u Joint's are broken. so modified #1. If the loyal and xt6 drive lines are the same i can Swap them from my 86 gl wagon into the xt6? Are you talking the driveshaft joints or the CV axle joints? As far as I know, the CV axles are the same.
May 28, 201213 yr I also bought u joints and somewhere on here are staked instructions here http://www.rockforddriveline.com/Staked_Instructions.htm
May 28, 201213 yr Author I also bought u joints and somewhere on here are staked instructions here http://www.rockforddriveline.com/Staked_Instructions.htm Thanks for the link. I do believe that I need the whole U joint. Problem is not sure what it is considered "stacked or non rebuild able" I am looking for the easiest fix (fastest) and then I can worry about the broken U joint.
May 28, 201213 yr Ive never seen an lsd rear in any xt6 although they show in the fsm. How rare? Why are they so rare? I have a 5spd xt6 with rear lsd and diff lock. I didn't know they were a rarity tho! Is this set-up particularly desirable? Sorry for jumping in, my interest is just seriously peaked now. Edited May 28, 201213 yr by natext6
May 28, 201213 yr Author How rare? Why are they so rare? I have a 5spd xt6 with rear lsd. I didn't know they were a rarity tho! Is this set-up particularly desirable? Sorry for jumping in, my interest is just seriously peaked now. Well lsd everyone wants so it is "rare" but just set up wise its rare since a lot weren't produced or it was a option when buying the cars from dealership. And no worries I'm just getting into xt6's so I'm learning as well. I also looked around on the xt6 forum and found a lot of people swapping svx trannys (5 speed) to replace their automatics.
May 28, 201213 yr Wait.....svx 5spd tranny??? Svx's only came with the 4eat auto trans (same trans used in the 87.5 and later xts. (If I'm not mistaken?)
May 28, 201213 yr Author Wait.....svx 5spd tranny??? Svx's only came with the 4eat auto trans (same trans used in the 87.5 and later xts. (If I'm not mistaken?) Yeah my bad. But they swap 5 speed granny's from Something else. Umma re read that post again... Got my facts wrong oops haa
May 28, 201213 yr I'm pretty sure you're thinking ej tranny swaps. For the most part they have the same doj spline count as ea82 turbos and er27 (25 if memory serves) so theyre the easiest to implement. they do need adaptor plates tho to be able to fit up to the engine.
May 28, 201213 yr Author Yeah. I can't find that article either now but that sounds right. So I guess back to the first q I posed, I will just pull my wagons drive shaft gl, measure and then compare it to the xt6's when I finish paying it and get it home. Thankfully it's 7 miles away and he took the add off. I will get pics up when I have the chance
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now