Jump to content
Ultimate Subaru Message Board

fuel sender wiring ?


Recommended Posts

So im not getting power to my fuel gauge and i suspect the connector by the floor on the drivers side that is for all the wires that run accross the dash to the stuff in the back such as the fuel pump. im having troubles locating a wiring diagram to figure out which wire on that connector is for the sending unit. any help would be appreciated.

Link to comment
Share on other sites

The wiring runs along the passenger side door sill harness/ The gas tank sender to body harness plug is located in the passenger side cargo well in the rear quarter panel under a metal plate mounted by screws. Inspect for debris or corrosion. Good luck

Link to comment
Share on other sites

Looking at some data for a different model it shows the wire from the gauge is a brown/white wire. The two senders are in series with each other tied together via a blue wire and end with a blk/yel wire from the second sender tieing to ground. Your model might be the same possibly. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...