cnc Posted October 19, 2015 Share Posted October 19, 2015 Hi, Left rear passenger window blew to bits, just standing there. (wth?) Got replacement from the bone pile (Pick-n-Pull) but how the heck do you get it inserted back in there? Tried the usual jiggle-wiggle-pull-cuss approach with no results. There must be a sequence of things to do. ??? cnc Quote Link to comment Share on other sites More sharing options...
Crazyeights Posted October 19, 2015 Share Posted October 19, 2015 (edited) [EDIT] because I can't read sometimes... Edited October 19, 2015 by Crazyeights Quote Link to comment Share on other sites More sharing options...
cnc Posted October 19, 2015 Author Share Posted October 19, 2015 (edited) This is not a windshield, rear window, or rear fixed window. It's the power door window behind the driver. There is no putty anywhere it, but thanks for chiming in anyway. I did manage to get it installed, but it's not sitting quite right. The trick I found was some stops needed to be loosened and slid out of the way. I wish there were some good instructions somewhere. I just had to try every conceivable thing. Edited October 19, 2015 by cnc Quote Link to comment Share on other sites More sharing options...
DaveT Posted October 19, 2015 Share Posted October 19, 2015 Factory Service Manual probably has them, and how to adjust them. Quote Link to comment Share on other sites More sharing options...
cnc Posted October 20, 2015 Author Share Posted October 20, 2015 I don't have one of those. Where do you find one? Quote Link to comment Share on other sites More sharing options...
DaveT Posted October 20, 2015 Share Posted October 20, 2015 There may be some online scans. I've seen them on ebay sometimes. I bought mine from dealers a long time ago. Quote Link to comment Share on other sites More sharing options...
scoobiedubie Posted October 22, 2015 Share Posted October 22, 2015 I have replaced that window several times. You are going to have to remove the outside bottom window trim. There is a screw at each end, as I recall. Removing the white roller guides is also required. The window is held to the sliding mechanism by 2 bolts. If you have electric windows, you might need to set the window in a particular position that allows some tilting and sliding to work the wheels out through hidden slots in the upper part of the door. Use lots of lithium grease in the guide rails, wheels and other moving parts, before you reinstall the window. Quote Link to comment Share on other sites More sharing options...
cnc Posted October 22, 2015 Author Share Posted October 22, 2015 Scoobie, Thanks. I did manage to get it put back in, but didn't grease anything. Sounds like a good idea to open it up again and do that. The window isn't setting quite right, so need to tweek it a bit, anyway. I think the glass is sitting up a bit too high and when I close the door, it catches on the upper rubber, but if I kinda push it inward as I shut it, it's fine. Or, I can shut it with the window down a bit and then roll it up afterwards. That kinda wedges it in tight. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.