Greetings:

 

My new 2005 Legacy 2.5 GT Power stirring fluid level was below the Cold Min mark. While trying to fill it up with Dexron III, my hand just slip and I overfill a bit higher than Cold MAX mark. I don't think this is going to be a big issue, isn't it?

 

Any additional comment is greatly appreciated.

likely all that will happen is that some of the PS fluid

will "foam" out...

 

meaning it'll flow out the cap and get all over everything

 

but that's about the most "damage" i can see occurring

 

if you're worried about it...

 

remove some of the fluid (with a baster or a siphon tube)

 

Jamie

youll make a mess all over that nice clean engine thats all

 

 

nipper

If it worrys use a turkey baster and take soem out...just make sure to buy a new turkey baster....

Thank you all for your comment and good tip with siphon or baster.