njchen24 Posted November 13, 2005 Share Posted November 13, 2005 Greetings: My new 2005 Legacy 2.5 GT Power stirring fluid level was below the Cold Min mark. While trying to fill it up with Dexron III, my hand just slip and I overfill a bit higher than Cold MAX mark. I don't think this is going to be a big issue, isn't it? Any additional comment is greatly appreciated. Quote Link to comment Share on other sites More sharing options...
Subie Gal Posted November 13, 2005 Share Posted November 13, 2005 likely all that will happen is that some of the PS fluid will "foam" out... meaning it'll flow out the cap and get all over everything but that's about the most "damage" i can see occurring if you're worried about it... remove some of the fluid (with a baster or a siphon tube) Jamie Quote Link to comment Share on other sites More sharing options...
nipper Posted November 14, 2005 Share Posted November 14, 2005 youll make a mess all over that nice clean engine thats all nipper Quote Link to comment Share on other sites More sharing options...
Smpol19 Posted November 14, 2005 Share Posted November 14, 2005 If it worrys use a turkey baster and take soem out...just make sure to buy a new turkey baster.... Quote Link to comment Share on other sites More sharing options...
njchen24 Posted November 14, 2005 Author Share Posted November 14, 2005 Thank you all for your comment and good tip with siphon or baster. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.