markjs Posted February 3, 2006 Share Posted February 3, 2006 It makes it hardly run and I had to dry the cap! Quote Link to comment Share on other sites More sharing options...
4 arm boxer Posted February 3, 2006 Share Posted February 3, 2006 silicone. Quote Link to comment Share on other sites More sharing options...
markjs Posted February 3, 2006 Author Share Posted February 3, 2006 Just around the cap mating surface? Quote Link to comment Share on other sites More sharing options...
torxxx Posted February 3, 2006 Share Posted February 3, 2006 yup thats the only place water can get inside.. Also use dielectric grease on your plug wires and top of cap. Quote Link to comment Share on other sites More sharing options...
Indrid cold Posted February 3, 2006 Share Posted February 3, 2006 I also got this from another post and thought it was clever: Take Latex/Nitrile glove. Snip off just the end of each finger, push plug wires through and plug into distributer (4-plugs, 1-coil wire) then pull glove down over cap and zip tie close at base also zip tie each finger end. Quote Link to comment Share on other sites More sharing options...
Turbone Posted February 3, 2006 Share Posted February 3, 2006 Drive slower thru the puddles Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.