Ok, I've got the list of jets needed for an EA81 application, but I can't find any info on the emulsion tube sizes or the accelerator pump jet size. I have three carbs, one of which I will use on my Hatch. One is an olser genuine Weber(no jets) in need of a serious cleaning, and two are Holley 5200's. The Holleys are spotless inside and out, but only one has jets. I looked at one and the jets are 132/132, 185/195, 90/50 , accel 80 !!!

 

I will buy new jets with my adapter but I need to know the correct emulsion tube size and accel. pump jet size for the 140/140, 170/160, 50/50 set up.

 

Thanks

I think that Maybe Here: www.webercarburetors.com They got the Parts, and maybe they can Halp you...

 

I obtained my Weber 32/36 for my EA82 wagon from That Site, they´re so Kind, so Maybe they can Help you.

 

Good Luck!

Emulsion tubes should be F-50's

 

Accelerator pump I can't recall at the moment. But there's an accelerator pump jet, and there's an accelerator pump nozzle - both have sizes that should be checked.

 

GD

Thanks, I'll keep digging.

Well, I can't seem to find a list anywhere on the net that shows what the accelerator jet and nozzle size should be. Does anybody remember what your weber has in it?

Does anybody have any idea how to convert emulsion tube sizes? I have 5 carbs I'm using for parts, and only one I could get the emulsion tubes out of. It had a 16 and a 94 ???? Not F6 or F50 that I expected to see.

 

I found out about the acellerator sizes. i found that the nozzle is 50, and the bleed is 30. I guess the nozzle is the jet, that's good since I have a few that size. But where is the bleed??