Hey guys hows it going!
I've been having problems with my wheeler wagon losing exhaust studs. I need to know how to get them to stick in there. i was thinking about using something like high temp JB weld or something similar, but i dont think it is rated hot enough for exhaust studs.
What is going on, is that whomever had this engine before me heli-coiled all of the exhuast stud holes. It is a JDM dual carb EA-81s engine so i believe you have to drill new exhaust holes anyway, because JDM manifolds are 180 degrees off than 'Merican manifolds.
I have a spare motor if it comes to that but i would rather use my fancy engine over a stock one.