Jump to content
Ultimate Subaru Message Board
jj421

Complete Cone Washer Failure

Recommended Posts

The "flat washer" is a spring washer, it isn't flat.  The concave side goes against the cone washer.

 

To avoid the problems at the beginning of this very old thread, make sure the nut is tight.  Re check it a few drives later, also.

Share this post


Link to post
Share on other sites

Yes the domed side goes towards you, the newer ones are marked with "out" but I just picked up two sets of wheel hub hardware and the one nut was marked on the right side but the other said "out" on what was really supposed to be "in, so always just look for the convex and put it towards you

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×