Hey everyone, while I am no longer making lifts on a regular basis, I do still have blueprints of all the lifts I offered available. They are $25 each, and can be emailed or snail mailed upon request. I have the following blueprints available:

 

Gen 1 (1977-1981 Brat, 1977-1979 Wagon, Sedan, Coupe) - 4"

 

EA81 (1982-1987 Brat, 1980-1989 Hatchback, 1980-1984 Wagon, Sedan, Coupe) - 3", 4", 6"

 

EA82 (1985-1994 Wagon, Sedan, RX, 3-door Coupe, Loyale, Loyale RS; 1985-1992 XT, XT-6) - 2", 4", 6"

 

PM me or give me a call. Paypal and money orders are preferred. Thanks

 

-Bill

Bill is the man, and you can't go wrong with his stuff. 

I thought for sure one of the boards welders would have jumped all over this for something on the side.

I thought for sure one of the boards welders would have jumped all over this for something on the side.

I would if I had the time. Still might. It would be a good way to make some money for my project during the summer. 

does anyone have these blueprints?  i am looking for a couple different ones. ea 82, and gen 1

 

thanks

 

Craig

Me too....gen 1 wagon....want to convert from 2 wheel to 4 wheel....anybody know what the minimum lift I would need to make that clear the crossmember?

Thanks

Estimate of how much it would be to get a place to make these up?

I spoke with Bill a few months back and at the time he had no access to a computer to email and deal with making and selling blueprints. Hoping that the situation changes.

I spoke with Bill a few months back and at the time he had no access to a computer to email and deal with making and selling blueprints. Hoping that the situation changes.

 

Is this still the case? What happened to him? I used to see him around on the forums a lot a few years back - is he OK?