Jump to content
Ultimate Subaru Message Board

Recommended Posts

Just bought a new 2006 Outback. WOW. I'm hooked. Put 1000 miles on the first week. Can't get enough.

 

One of you Soobie nuts who are obsessed as I'm becoming must know how to SHUT THIS !@#$ Seatbelt alarm off. Dealer says against the law to shut it off or tell me how. Maybe, Maybe not. But there is always other ways.

 

There are times when I just can't wear it even most of the time I do.

 

Thanks

 

Overthehill.

Link to comment
Share on other sites

I'm no lawyer, but disabling the alarm would be defeating a safety device. Your insurance company may prohibit that, and for all I know it might even be illegal.

 

Defeating the chime would be simple, but don't do it. Crashing the car without a seatbelt is Bad For You. So wear a seatbelt all the time. And if there's some bizarre reason you can't wear a seatbelt, then buckle the seatbelt in and sit on top of it.

Link to comment
Share on other sites

There is a weird on off way of doing it ... let me see if i can find the way of doing it. Its a luducrously complicated method of on of's if i remeber correctly.

 

 

found it....

 

The seatbelt chime can be turned off by the user. Just turn the key to the

ACC position and begin buckling and unbuckling the seat belt as soon as the

chimes start. Remember to wait until the seatbelt icon stops blinking before

unbuckling. Repeat twenty buckle/unbuckle repetitions and remove the key.

The chimes should be disabled the next time you start the engine. The

process seems to be finicky so you may need to repeat it several times

before it takes hold.

 

 

this is from an edmunds board on outbacks

 

 

 

nipper

Link to comment
Share on other sites

Thanks Nipper. I will give it a try and let you know how it went.

 

Overthehill

 

There is a weird on off way of doing it ... let me see if i can find the way of doing it. Its a luducrously complicated method of on of's if i remeber correctly.

 

 

found it....

 

The seatbelt chime can be turned off by the user. Just turn the key to the

ACC position and begin buckling and unbuckling the seat belt as soon as the

chimes start. Remember to wait until the seatbelt icon stops blinking before

unbuckling. Repeat twenty buckle/unbuckle repetitions and remove the key.

The chimes should be disabled the next time you start the engine. The

process seems to be finicky so you may need to repeat it several times

before it takes hold.

 

 

this is from an edmunds board on outbacks

 

 

 

nipper

Link to comment
Share on other sites

Not a joke i can give you the original source if you want (once my email puter kicks in).... its touchy, sometimes it works and sometimes it doesn't. Otherwise you just live with it.

 

 

I only joke iif it envlovles slaughtering a small animla and chanting over the engine computer on a full moon with ans easterly wind....

 

nipper

Link to comment
Share on other sites

Ok here is the original email i got from a yahaoo list....

And it talks of sitting there with the car running in park

 

nipper

 

To: outback@yahoogroups.com

Sent: Wednesday, October 05, 2005 8:22 AM

Subject: RE: [outback] stopping 05 Outback seatbelt chime?

 

 

Rich:

 

I don't have time to find the posting right now but on one of the Edmunds

Town Forum boards there are directions on how to turn it off. I believe it

is in a 2005 Outback discussion board. I saved one of the messages,

hopefully this will be enough detail. If it does not work let me know. I

think this needs to be done within a 30 second time period. Here is the cut

and paste:

 

 

The seatbelt chime can be turned off by the user. Just turn the key to the

ACC position and begin buckling and unbuckling the seat belt as soon as the

chimes start. Remember to wait until the seatbelt icon stops blinking before

unbuckling. Repeat twenty buckle/unbuckle repetitions and remove the key.

The chimes should be disabled the next time you start the engine. The

process seems to be finicky so you may need to repeat it several times

before it takes hold.

 

 

Good luck.

 

Karl

 

> -----Original Message-----

> From: outback@yahoogroups.com

> [mailto:outback@yahoogroups.com] On Behalf Of Rich Rubel

> Sent: Tuesday, October 04, 2005 9:05 PM

> To: outback@yahoogroups.com

> Subject: [outback] stopping 05 Outback seatbelt chime?

>

> Just got an email off-list from someone wondering if there's

> a way to turn off the intermittent seatbelt chime/flash

> reminder in an 05 Outback. Not that they plan to drive w/out

> belts, but even if you're sitting somewhere with the engine

> running and the car in park, you get the chime.

>

> Anyone got an idea?

> Thanks.

> [RICHR]

 

 

 

To subscribe/un-subscribe vist http://groups.yahoo.com/group/outback

Link to comment
Share on other sites

First - it isn't a joke, I just did it in my '06 WRX wagon.

 

It will not disable the initial chime - just the repeat chiming.

 

I used the 'on' postion. dunno if ACC works or not.

 

I did the buckle/unbuckle starting immediately after switching to the 'on' (not starting though) position. I probably did it over 20 times in under 30 seconds, confriming that the warning light in the gauge cluster went off each time. It helps to sit on part of the belt after pulling it all the way out or otherwise prevent the retraction spring from pulling on you during the procedure. I postioned my right hand on the release button and concentrated left hand duties for insertion and 'catching' the tab when ejected after pressing the release button. I HAVE read of folks trying multiple times to get it to work. Perhaps I was just lucky. haven't tried it on the wife's '03 OBW so I don't know what years' cars this is effective on.

 

fyi

Link to comment
Share on other sites

  • 5 years later...

I just had to repeat this on my 2006 outback after a dealer reset

 

So with the seatbelt disconnected, switch key to ON position, then begin

the 20 insert/remove procedure, After unclicking the last time, turn the key forward and start the car before switching it off.

 

That did it for me but it took 2 attempts...

 

I wear the belt while driving but having that darn alarm disabled

definitely is the secret to lifelong happiness and well-being.... Ha!

 

Peace be with

Link to comment
Share on other sites

  • 1 year later...

Worked on my 06 Outback first attempt, yea!

 

There are times when I'm in my car with it running and i'm not wearing my seatbelt. Example, my wife and I are taking a break and she's nursing my son and we got the a/c on....don't need to wear a seatbelt in the parking lot.

Link to comment
Share on other sites

Yeah, I did this on my 06 Legacy when I had it. The seat belt chime is so freaking annoying!

 

Just an FYI for those folks that haven't owned a newer Subie, the seatbelt chime goes off if you just sitting there parked with the engine on. I agree you should definitely wear your seatbelt, but if you're doing some testing or other type stuff where the engine is running and the car is sitting there, you want to rip out the seat belt chime....that's how annoying it is ;)

Link to comment
Share on other sites

My '02 OBW is the same as yours. I guess we are the lucky ones that get to enjoy a few short, quiet dings, and then not have to be annoyed. :)

 

I'm sure it changed at least in '05+ in US Legacy's/OB's.

 

hmm... wonder if there was something similar done with 02 outbacks, i got mine used and always wondered why it didn't do seatbelt alarm/light for more than a few seconds when i start it.
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...