What is the best sealant to put the oil pump back on with? The anaerobic sealant it says to use in the Haynes manual, I cant find around here.

I don't recall what the Haynes manual recommends, but you can use any of these 3:

 

Threebond 1215

3M T-3 Silicone (black) #08670

Loctite-Permatex #599 Ultra Grey <--I've found this at PepBoys

I don't recall what the Haynes manual recommends, but you can use any of these 3:

 

Threebond 1215

3M T-3 Silicone (black) #08670

Loctite-Permatex #599 Ultra Grey <--I've found this at PepBoys

 

Permatex is the way to go, just dont use a lot of it

 

nipper

Thanks, I found 599 Ultra Grey, could not find the Threebond 1215.

I don't recall what the Haynes manual recommends, but you can use any of these 3:

 

Threebond 1215

3M T-3 Silicone (black) #08670

Loctite-Permatex #599 Ultra Grey <--I've found this at PepBoys

Threebond is a Fuji-branded sealant and there's a part number for it which I think I have, but it's not worth the expense.

What is the best sealant to put the oil pump back on with?.

Anaerobic sealant can be found at NAPA (ask if you're not sure) and is the best to use. RTV will work. Anaerobic sealant if any gets in the oil will not clog up oil passages or get stuck anywhere like RTV can, that's the only difference. that's why they're telling you to don't over-do the RTV. if you do and excess gets squeezed into the oil supply that's not a good thing. there's a picture on yahoo XT6 groups of a glob during a tear down someone did after a glob worked it's way into the engine. I used RTV for a number of years, i use anaerobic now because i have it on hand.