Skip to content
View in the app

A better way to browse. Learn more.

Ultimate Subaru Message Board

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

CB radio?

Featured Replies

after going in circles trying to use the search feature...How hard would it be to mount a small CB on the roof,right infront of the T tops on my brat?Are there any hot wires near the roof to tap into?

 

I know I shouldnt worry about CB's and other stuff when my brat doesnt even run but....gives me something to do.

Your dome light is probably the closest power source.

 

Shouldn't be that tough to tap into.

 

How are you planning on suspending the radio?

What are you going to hook that into?

It shouldnt be too hard to do. Im sure you could come up with a way to mount it.

 

I mounted a CB to the roof of my wagon, but the headliner isnt plastic like the brats... so it was as easy.

 

-Brian

  • Author

Im thinking self taping screws with a little cradle.Until I figure out how to boost the signal it will swing 7 watts through a 102" whip.little unidens swing 7 watts:grin: How hard would it be to get it to swing 20?

go to your brat and take the middle cover off.it is literally a snap and go event.then you will see how easy it is.i would not ruhn power through your overhead light.the guage of wire is very small and you run the risk of burning it up.it is about a 20 minute event to take everything off in order to run cable for your antenna and run a power wire.hella easy.

  • Author

If a 102" whip towers 7 ft above my brat how tall does that make the brat?

I mounted the whip on a braket just below the rear window.subi purists will flame me but I drilled right through the metal on the back of the cab and ran a 5/16" bolt though it,then a nut holds everything together on the back.then that plastic cover in the back of the cab covers the bolts...Im thinking of runing a coax cable from the bracket through one of the sides of a t top then connecting it to the uniden CB.

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.