Jump to content
Ultimate Subaru Message Board

Vehicle Speed Sensor in 99 Legacy...no speedo


Recommended Posts

I am having problems with the speedometer intermittently not working on my 99 Legacy 2.2.

 

I am assuming its the speed sensor on the trans?? Its an auto by the way

 

Where is the speed sensor on these new gen 4eat's?

 

Thanks for any input

 

~Tim

Link to comment
Share on other sites

Problem is not the speed sensor. Speedometer works off a sensor on the differential. Had the same problem in my 95. My solution was to just swap out the instrument cluster. A new sensor didn't solve anything.

 

Yes if there is no CEL the senser is fine. Usually in the 99's cleaning up the grounds inside the spedo head solves the issue. If not then you have to replace it. There was a bad run of spedos in that year.

 

 

nipper

Link to comment
Share on other sites

I have a 99 Legacy outback, and fought this very gremlin a few months ago.

 

As others have noted, It's probably not a sensor. I was able to convince myself of that fact because (in my case) the speedometer would flicker back to life when I pressed in the trip reset button.

 

If you search through the thread archives, there are volumes of good advice. Most of the suggestions involve disassembling the dash, and cleaning the contact points on the speedometer - especially the area where the negative terminal on the copper/laminate circuit board meets a particular ground screw. Another good suggestion I ran across was to supplement the grounding by running a wire from the ground screw to the chassis of the vehicle.

 

Alas, none of the solutions worked in my case. Within a couple weeks, I went to the dealership, bought a new speedometer and the legally mandated sticker for the door frame indicating the car's mileage has been altered. Good luck.

Link to comment
Share on other sites

Update,

 

I swapped out the cluster with one from a 97 GT and the speedo still doesnt work, The cruise works fine, could it be that the 97 Gt cluster isn't compatible with the 99?

 

I am going to try to tear apart the 99 cluster and clean it as mentioned but shouldnt the 97's cluster be ok?

 

Thanks

~Tim

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...