RdNkBrt Posted July 17, 2007 Share Posted July 17, 2007 Alrighty, so I know I've read threads on this before, but i can't seem to find them not that it actually affects me....#1: How much modification is required to put a gen 1 roll bar onto a gen 2 brat? #2 are there any other trucks with roll bars that will fit without much modification on a gen2? Such as a yota or little dodge or chevy? Again, I'm sorry for asking an old question, but i'll appreciate any reply's, even useless ones! Quote Link to comment Share on other sites More sharing options...
Turbone Posted July 17, 2007 Share Posted July 17, 2007 A cutting torch will make anything fit:grin: Quote Link to comment Share on other sites More sharing options...
RdNkBrt Posted July 17, 2007 Author Share Posted July 17, 2007 thanks turbone! I knew if i put in that request for useless comments bit that i'd recieve at least a few!!! hahaha:Flame: Quote Link to comment Share on other sites More sharing options...
86BRATMAN Posted July 17, 2007 Share Posted July 17, 2007 Our world is flat... I've seen a yota roll bar in a gen2 before. I think the legs had to be shortened some. It's been a while so I can't be for sure Quote Link to comment Share on other sites More sharing options...
Turbone Posted July 17, 2007 Share Posted July 17, 2007 thanks turbone! I knew if i put in that request for useless comments bit that i'd recieve at least a few!!! hahaha:Flame: I aim to please;) I'm trying to fit a Gen 2 rollbar into a Hatch. Now thats fun! Quote Link to comment Share on other sites More sharing options...
mcbrat Posted July 17, 2007 Share Posted July 17, 2007 Alrighty, so I know I've read threads on this before, but i can't seem to find them not that it actually affects me....#1: How much modification is required to put a gen 1 roll bar onto a gen 2 brat? #2 are there any other trucks with roll bars that will fit without much modification on a gen2? Such as a yota or little dodge or chevy? Again, I'm sorry for asking an old question, but i'll appreciate any reply's, even useless ones! it depends on the type of Gen1 bar, but the last one I did it to, I had to make the back legs 2" shorter.... Quote Link to comment Share on other sites More sharing options...
fshnidiot Posted July 17, 2007 Share Posted July 17, 2007 I have a gen 1 tall rollbar I'm going to put into my 82 Brat. It looks like I'll have to drill new holes in the plate to get it to bolt into the bed behind the cab and the legs that go to the fenderwells will need modification/shortening too. I might just go without them. Other than that it should be an easy fit. Frank (fshnidiot) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.