what is the ratio of a ring gear stamped

S37:10 DB 7 11 16 . .

 

also, what is the recommended gasket or sealer for the rear diff access cover plate?

what is the ratio of a ring gear stamped

S37:10 DB 7 11 16 . .

 

also, what is the recommended gasket or sealer for the rear diff access cover plate?

 

that's a 3.70 ratio. I have one with the same numbers on it sitting on my desk at work

 

I've done new gaskets before when building the 3.90 LSD.

But also have re-used when they came apart cleanly.

thanks Mick i knew you could help.

so i need ring gear with S39:10 lol

 

and new gasket for access cover

and bolts for holding the ring gear to the LSD

and stub bolts

and stub covers/seals

and the bolts for them stub covers.

 

This will be fun but very doable, i have time i hope.

got a pic of that special socket for the stub bolts? I think my dad prob has the tool if i know what it looks like.

oh, and yeah i want to keep my existing open diff complete and intact, in case this doesnt pan out so well....

http://buy1.snapon.com/catalog/item.asp?P65=&tool=hand&item_ID=14957&group_ID=2358&store=snapon-store&dir=catalog

 

if you get my spare diff, you'll just need the diff cover gasket....

and some lsd gear oil. and some grinding of the pumpkin

http://buy1.snapon.com/catalog/item.asp?P65=&tool=hand&item_ID=14957&group_ID=2358&store=snapon-store&dir=catalog

 

if you get my spare diff, you'll just need the diff cover gasket....

i hope.

got a pic of that special socket for the stub bolts? I think my dad prob has the tool if i know what it looks like.

 

A 10mm twelve point deep socket works.

Just get some gasket paper and use a ball bearing to knock out the holes for the cover.

 

GD