July 11, 201312 yr Author Rewired the injectors. Found out my map vacuum line location was in a poor spot, having my friend/boss go over the tuning. It's moving along pretty well. Unfurtunetly he is super OCD so my wiring may get pulled apart and redone. So we can put the companies stamp of approval on it. Lol Also I need to locate a stock turbo to fall into class guidelines
January 25, 201412 yr Author Yada yada yada, car has sat. Somewhat. Decided forget autoX with their stupid rules I'm building an all out what can this ea do RX with much awsome. Getting back to work on it. The manifold is currently being modified to fit a wrx injector with a areomotive style rail with an lines so on and so fourth, I gotta 5 lug the car, pulling a set of carb'd pistons to send to CP to have a forged set made. The celica intercooler got chucked in lue of a jdm legacy A2W with a jaspco pump. The distributor is getting milled to put a dust cap on it and I'm gunna run a ls or subaru coil (like the 22 ones) and I'm stripping the car for a cage and such Partial gutting: Edited January 25, 201412 yr by rpholz
February 19, 201412 yr wow, i hadnt seen this car in a long time. on that note, what happened to WJM??
February 20, 201412 yr Just read this whole build thread while I was in my macroeconomics class, this is way more interesting than hyperinflation. I am thinking of TD04ing and camming an EA82T, I want to see what success you have on this.
February 20, 201412 yr Author Subyrally- pm sent. AWD j3wman- prepare for a little wait, bouncing between this and my XT. I bought frankenwedge which is a eg33 swapped xt6 with some work that needs to be done to make it a good DD
February 21, 201412 yr Subyrally- pm sent. AWD j3wman- prepare for a little wait, bouncing between this and my XT. I bought frankenwedge which is a eg33 swapped xt6 with some work that needs to be done to make it a good DD well i got a 91 Civic im building also so its still a year or 2 off
March 2, 201412 yr Author Went ahead and tapped the fuel rails for -6 AN lines. Cut out the back of the glove box so I can make a panel to hold the haltech and wideband controller. Figured out the IC to TB piping, just gotta cut it and weld a flange for the BOV and IAT sensor. I need modify the dog bone bracket so it all clears better
March 8, 201412 yr backing plates found, not much more than some surface rust and a whole mess of spiderwebs and dead stuff *cringes* i hate spiders
March 9, 201412 yr Author Oh how much?! That would be a life saver! Hopefully without spiders...... Right? Also! My initial suspension settings are a bit..... Low
March 11, 201412 yr Author Harness revision V1.1 I still need to run power for the injectors but all the important bits are there Also, I think I might start hunting these down.......
March 14, 201412 yr dont think i have forgotten about you and the backing plates, i have been busy this week, but i am going to try to get you a shipping quote this weekend. i will let you know what i find out.
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now