Leaderboard
-
Britfire
Members2Points4Posts -
silverhelme
Members1Points399Posts -
STi 22B
Members1Points87Posts -
rickyhils
Members1Points224Posts
Popular Content
Showing content with the highest reputation on 09/02/19 in all areas
-
So after some phone calls to Subaru USA, a very helpful guy there dusted off the shelves and sent me pictures of the transmission diagrams and part lists. From that I was able to source the last Brat transmission rebuild kit in the country!2 points
-
Do a search for starter relay mod. I did it to my Brat and never had another problem. It's been ten years.1 point
-
3500 RPMs is just getting to the powerband. And it's fine to cruise at those RPMS If you need more power up the hills, use lower gears and let the engine rev out at a light throttle, rather than using a higher gear and having to struggle even with throttle wide open. It can take 4500 all day.1 point
-
I was thinking exactly the same but was trying to keep post brief1 point
-
My guess (not that I know much about this stuff) is that IF the rubber block is facing down, then there is a chance of it falling out when it (if ever) gets worn out. I'd bolt it rubber side up1 point
-
Thanks you guys. Best way for me was to slice through strut bracket and bend the new "tabs" in opposite directions till brake line can pass through. And no critical loss of structural integrity. No need to disconnect brake line. All you guys are the best. thanks1 point
-
1 pointThe WIX filters are the only one's I'm aware of that have the 23.5 psi bypass valve and have the valve up-front before the filter element. They are a significantly better design as when they go into bypass (one every cold start for example, when Subaru oil pressure is 90+ psi) the oil does not first pass over the dirty element and wash contaminants back into the engine. GD1 point
