Search the Community
Showing results for tags 'flasher'.
The video tells the story!!! The left turn signal switch will activate flashing in bulbs other than the turn signal bulb! https://youtube.com/shorts/AtWGv5Lt3ns?feature=share
I am having some odd trouble with my brake light/blinkers/reverse lights and have searched this forum but haven’t found an answer to my exact problem. This is on a 1985 BRAT GL 4spd non-turbo EA81 car. The symptoms are as follows: -Press brake pedal- stop light lamp and RH turn indicator light up solid on dash. The taillights and stoplights do illuminate but the reverse lights do as well with the brake applied. -When I remove the RH tail/stoplight bulb- the conflict goes away and everything works as it should (with the exception of the bulb that was removed) -Also, when I turn on the emergency flashers, nothing happens. No lights on dash or on exterior and no clicking from the flasher module. -Both turn signals function normally when I move the blinker switch to either side (which leads me to believe that the flasher module is good). Could the flasher module still be faulty despite it working properly with the turn signals? Any help is greatly appreciated!
Hi, this is regarding my fathers car, a 2005 Subaru Baja AT Turbo, about 110K miles. At one point, his passenger side turn signal lights came on and stayed on (solid, not flashing). They are on even when you take the keys out of the car. To be specific, it's the front and rear pass. side turn signal lights, and the front pass. side parking light (which is affected because it would normally flash along with the turn signals), so 3 lights. On the dash the pass. side turn signal indicator (the green arrow) is lit up and always on too. The Drivers side turn signal lights work fine, they flash normally. But, when you push the hazard switch in, the drivers side turn signal lights come on and stay on like the pass side. There is no relay click when you do this, only the click of the switch when you push it in. Using the drivers turn signals and the keyless entry unit, we were able to track down 3 modules that make clicking noises & cause lights to flash, two when you use the drivers side turn signals (one with a black plug under the drivers dash, mounted to the steering shaft, and a larger one, on the left side of the drivers side foot well up under the dash. It has a white plug). The third one is the keyless entry/security module, it's behind the glove box. We unplugged all three modules to no effect, the pass. side lights mentioned are still lit up solid. Is there another relay that we couldn't find (and if so, where is it?) or is there possibly a problem with the hazard switch? Thank You.
I have a 93 impreza wagon. I recently switched the normal signal bulbs out for led bulbs. Since the leds draw less power, the car thinks a bulb is out and therefore causes the signals to flash very fast, almost to the point on a sunny day where they cannot be seen. I know I need a flashed relay of 5 ohm or less, however Ive stumped the guys at my auto parts store because they don't have one. Has anyone else ran into this problem? What I need to know is if anyone knows of a part # or which flashed relay I need to get?