September 9, 200421 yr Is this possible? I know generally a 25 spline trans is used with this conversion but I'm wondering if EA82 axles can be used or if the DOJ on the XT-6 axles can be swaped with the 23 spline.
September 9, 200421 yr Perhaps it would be easier to swap out the stub axles on the trans. If they work the same way as the rear diff... Also... i'm pretty sure cvaxles.com has made some of these for someone... oh! It was subarustyles.
September 9, 200421 yr www.cvaxles.com will make you a set of custom axles for your car with either the 23 or 25 tooth splines.
September 9, 200421 yr I am pretty sure (although not 100%) that the AXLE SHAFT itself is the same, just the joints are different, if that is the case then it would be a simple matter to buy a inner boot kit and put the 23 spline inner joints on the XT6 axles......
September 9, 200421 yr I am pretty sure (although not 100%) that the AXLE SHAFT itself is the same, just the joints are different, if that is the case then it would be a simple matter to buy a inner boot kit and put the 23 spline inner joints on the XT6 axles......The axle shafts are not the same, but the inner joint will interchange.
September 9, 200421 yr with some advise from corky i had cvaxles build me a set of xt6 ones with 23 inner DOJ #95lac
September 10, 200421 yr lol when we did the carbed ej18 swap we just slid the inner race of the ea DOJ into the 25 spline cup of the legacy DOJ..worked fine..ghetto, but fine ;-)
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now