cnc

Loyale Power Steering pump froze up, then works, again. ?

By cnc, November 17, 2017 in Old Gen.: 80's GL/DL/XT/Loyales...

• Loyale power steering seized

Power door locks keep blowing the fuse. 92 Loyale

By cnc, September 21, 2017 in Old Gen.: 80's GL/DL/XT/Loyales...

Loyale door lock switch fix hack.

By cnc, August 4, 2017 in Old Gen.: 80's GL/DL/XT/Loyales...

• door lock switch

Loyale tranny swap. Lost the backup lights. Need a diagram.

By cnc, March 26, 2017 in Old Gen.: 80's GL/DL/XT/Loyales...

• loyale transmission wiring

New brake pads and rotor too wide! ? '98 Outback.

By cnc, April 19, 2017 in 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX

Loyale e-brake seems to a have a partially broken cable. ?

By cnc, February 23, 2017 in Old Gen.: 80's GL/DL/XT/Loyales...

• Loyale parking brake

Rear hatch door release from inside mod?

By cnc, March 13, 2016 in Old Gen.: 80's GL/DL/XT/Loyales...

• rear door hatch release

Loyale:installing rear side window. Tips?

By cnc, October 19, 2015 in Old Gen.: 80's GL/DL/XT/Loyales...

• Loyale power window install

Alternator not charging: Dash light was to blame. Seriously.

By cnc, January 24, 2014 in 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX

Loyale rear wheel bearings won't budge and CV pin won't come out.?

By cnc, August 5, 2013 in Old Gen.: 80's GL/DL/XT/Loyales...

• rear wheel bearings pin

Need EA71 distributor with points

By cnc, May 13, 2013 in Old Gen.: 80's GL/DL/XT/Loyales...

Loyale 5 speed falling out of gear on downhills. ?

By cnc, June 14, 2013 in Old Gen.: 80's GL/DL/XT/Loyales...

• falling out of gear tranny

98 Legacy Outback rough idle, periodically

By cnc, September 12, 2012 in 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX

A/C technical manual? Where?

By cnc, July 2, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...

93 Loyale EA82 rough idle. Timing light jerky.

By cnc, February 20, 2012 in Old Gen.: 80's GL/DL/XT/Loyales...

EA82 Fel-Pro gasket o-ring seal?

By cnc, February 10, 2012 in Old Gen.: 80's GL/DL/XT/Loyales...

98 Outback hitch won't fit. Ideas?

By cnc, January 29, 2012 in 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX

EA82 cold start problem

By cnc, October 26, 2011 in Old Gen.: 80's GL/DL/XT/Loyales...

Fel-Pro head gaskets for EA-82??

By cnc, November 18, 2011 in Old Gen.: 80's GL/DL/XT/Loyales...

AWD vs. 4WD: Why the switch?

By cnc, March 3, 2011 in Old Gen.: 80's GL/DL/XT/Loyales...

AHA! Found the coolant leak. Tip for others.

By cnc, October 5, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...

Fan nut installation. Trick

By cnc, July 26, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...

Crank pulley fell off. How to prevent??

By cnc, July 26, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...

Fan nuts?? Crank pulley?? Gotta be a trick...

By cnc, July 22, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...

A/C pulser amplifier on Loyale: Where??

By cnc, July 5, 2010 in Old Gen.: 80's GL/DL/XT/Loyales...