Jump to content
Ultimate Subaru Message Board

12" wheels?


zed wolf
 Share

Recommended Posts

You have to make / redrill them.

 

There is a 12" rim in 4x130, its on the back of a japanese mazda bongo/ford econovan light commercial van that was fitted with dual rear tyres. Approx 1984-1990. The rims are 12"x4" wide and quite offset of course, being dual wheel. If you widen them by 4" you get a 12"x8" rim thats very sturdy and stops just shy of the caliper on subie.

 

This is them widened:

http://webhost1.inspire.net.nz/~nyloc/Toybaru/pages/Drivers%20side.htm

Link to comment
Share on other sites

A 12" rim will fit and clear all the brakes and steering components.

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=4967&sort=1&cat=500&page=3

 

The question is what are you going to do with a 12" rim?

 

If you mount a middle of the road tire "26 inch", you'll need a lift to clear them--depending on the width?

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=7438&sort=1&cat=500&page=2

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=7435&sort=1&size=medium&cat=500&page=2

 

A smaller tire would fit a bit easier.

 

Your stock tire should measure about 22.5"

A 26" tire measures out to about 25.5

 

Tell us what you have in mind?

 

Glenn,

82 SubaruHummer

84 GL Mad Max

01 Forester

Link to comment
Share on other sites

A 12" rim will fit and clear all the brakes and steering components.

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=4967&sort=1&cat=500&page=3

 

The question is what are you going to do with a 12" rim?

 

If you mount a middle of the road tire "26 inch", you'll need a lift to clear them--depending on the width?

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=7438&sort=1&cat=500&page=2

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=7435&sort=1&size=medium&cat=500&page=2

 

A smaller tire would fit a bit easier.

 

Your stock tire should measure about 22.5"

A 26" tire measures out to about 25.5

 

Tell us what you have in mind?

 

Glenn,

82 SubaruHummer

84 GL Mad Max

01 Forester

 

OY MY!! now this has got me thinking...I take my gl wagon to Baja for a few weeks each winter to chase surf and have to go to the well known spots with reasonable access and sometimes crowds BUT with a extra set of wheels/tires I turn the wagon into a "sand no trouble atv" and go to another spot with a friend or 2 that doesn't have the great access!!! yeah baby!! Cheers Pesky

Link to comment
Share on other sites

heres a set I rigged up they are 12" rims outer from a lawn tractor , with stock car rim centers

 

 

 

attachment.php?attachmentid=3021&stc=1

 

heres the tire I got

 

ag_lug_hf255.jpg

 

23x10.50-12 Ag Lug

 

they really go I wouldnt hesitate putting a fell set on a subaru, we took this machine to the sand dunes , goes great , is lacking on steep hills as its only front wheel drive

the lawn tractor rim is lacking as it has no bead lock ridge so you cant air down much ,

Link to comment
Share on other sites

well, my thoughts were about getting some atv tyres for trail use only.

they are easily found in up to 28" fairly cheap and have some wicked tread patterns.

 

yep, it's been discussed before....

 

long story short, they're not strong enough to hold up the weight of a subaru

Link to comment
Share on other sites

yes, even with lots of air, the most you'd do is blow out a sidewall, or a bead, or blow the valvestem out. Too much pressure plus a tire thats not supposed to take that much plus the addition of the weight which is going to be over the load capacity of the tire equals lots of BOOOOOM!!!!

Link to comment
Share on other sites

yes, even with lots of air, the most you'd do is blow out a sidewall, or a bead, or blow the valvestem out. Too much pressure plus a tire thats not supposed to take that much plus the addition of the weight which is going to be over the load capacity of the tire equals lots of BOOOOOM!!!!

 

 

 

i always thought it was more of a bang.......:brow:

Link to comment
Share on other sites

And they make atv wheels with a 4x135 (or something like that, it's close) lug pattern, but they're not even as strong as the wheels on your donut spares.

 

Sweet82 runs avt tires on custom wheels, but his buggy weighs a fraction of a full subie. It looks like he put those wheels on his wagon, but probalby just for test fittin, and pics.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...