So I came up with this idea since I have tons of spare stuff laying around and I don't feel like spending a small fortune on a lift kit. I'm going to try stacking the top hats for the front struts (I'm still working to see if that same idea might work for the rear) ill Remove the studs and use some grade 8 bolts That pull the top hats together. Also planning to double up the trailing arm spacers from my parts car for a slight body lift.

Comments? Opinions? Suggestions?

Edited April 6, 20187 yr by Jabbott126

Too thin. Bad idea. Get real lift blocks. 

 

GD

camber will be off. A lift block is offset to compensate.

Not safe.  Do not attempt

would have to agree with all of the above... Not a good idea, not by any stretch of the imagination.

 

If you want a lift, do it the right way - not hodge-podged together

 

small fortune on a lift kit

 for <$50 you can get front and rear spacers. Paranoid fabrications is one option.

Edited April 9, 20187 yr by wtdash

What ever happend to the napkin lift diagram that was a great resorce for a cheap 2" lift

+1 for not strong enough and not corrected for camber.

What ever happend to the napkin lift diagram that was a great resorce for a cheap 2" lift

+1