Scott in Bellingham

been lookin at the car and lookin at different options, pros and cons heres a list............................................................................2nd tranfer case Lower gears,weaker front diff studs because Im using a rear Diff Higher center of gravity as the engine and transaxle would be in stock height more weight with 2nd transfercase and frame to mount it,also second crossmember for engine support and 3 drive shafts instead of 1 keep stock transaxle................. lower center gravity , better clearence mid car, less of a aproach angle , less weight, less parts, less engineering, only one driveshaft to have made not 2

been designing a 8" lift for the EA cars so you can mount up a 2nd diff up front and add a transfercase, any interest? anyone want one? if so it would give me more incentive to figure out the details SJR

it time to get back on this heres the planned revised specs 4.10 toyota rear end 4.10 subaru rear diff upfront 31" mudders would like to get some 32 x 9.50 TLS Swampers eventually, will wait till its runnin dual transfercases, stock subaru and Nissan 720 bob the rear pinch the front winch mounts front and rear transverse buggy spring in rear with tons of flex with airshock overrides engine not sure may go EA81 or carbed EJ or Atomic flux capacitor would like to have it up and going for this summer season of Walker wheelin

heres mine Ive never used the allingment dowels

what Ratios are ya runnin

My PC is on the fritz so I havent been on line, but thats a stock wheelbase with 6" lift and some 30" tires , if we run the Toyota rearend with the 4.10 gears we could run 31" tires in the rear and 29.48 tires on the front with the stock 3.9 , sorry no T-case no needed with the EJ with Delta Cams and the weight loss program

cool do it

I wont be there , but you can stop by in the evening if you like maybe 6:00

Bill I got all the body bolts if you need some help SJR

this is what I was thinkin :banana::banana:

maybe on a Saturday for me

I do for the the gen1 Legacy (90-93?) ,also have the front and rear strut tower parts to weld up your own towers , may be same I dont know SJR

Blocks placed between all suspension parts and body, so you could call it a body lift, will drop the engine crossmember for more engine room SJR

bring the kit when you pickup the engine

what bolts ( size and length and pitch )do you need?

push buttons fine unless you go with big tires say over 25-26" and want to do hill climbs

Bill when should I expect mine? remember trhe swaporu

Damage John got a hot clutch, I almost ran out of gas , the low light was on

good times lots of Fog but no snow, made my goal was to make it to the pit and go sledin well no snow, had to tug on John one time and he had to push me off a rock one time so we are even

mine bolts up to the stock holes

Can someone bring a Map as I dont know the roads up high thanks

Ill drive threw Joes parking lot at 9 then up to walker

yes I could do that , would it be 5" tall Im guessing not 3" tall

1/8" dont make it to heavy its 3" x 1/8 tube I will sell you those front brackets if you want to make your own

oh I mean the stock EA82 disty or maybe some of you electronic wizards can tell me how to run them coil packs without the disty just use the sensors on the crank and cam and somehow make them coils spark without the computer